Home Products ADP - Interface Relay Adaptors ...110 & 24 Vac coil ADP-1102-TWP

ADP - 1101 - 10AS - (120Vac controlled line voltage to Switch 24Vac)

HMI  Interface Relay Adaptors

HMI Hoyme ADP- 1101 - 10AS

This Adaptor  ADP-1101-10A S  is an automatic control swit­ch designed to operate with 

ADP-1101-05A or   with  ADP-1102-TWP to:

1.   Be connected to two exhaust fans, either one to operate from its own exhaust fan switch but is  interlocked to prevent the two exhaust fans from operating at the same time;

2.   To simultaneously turn on the furnace circulation fan for either exhaust fan;

3.  To simultaneously open a Replacement/ Ventilation damper (if used) for either exhaust fan.

Note: If the replacement air  damper is to also  open during the  firing cycle of the furnace, replace  ADP-1101-05A with  ADP-1102-TWP.

Installation Instructions - Printer friendly (pdf)


Colored Wiring Diagrams used with the ADP-1101-10AS  

#5B2. 120Vac vent fans & switches(2), one furnace, replacement air damper(Power Open)

#5B3. 120Vac vent fans & switches(2), one furnace, replacement air damper(Power Close)

#6A7. 1
20Vac vent fans & switches(2), one furnace, replacement air damper(Power Open)

#6A8. 1
20Vac vent fans & switches(2), one furnace, replacement air damper(Power Close)



Last Updated (Monday, 19 September 2016 11:36)